Get the lowest amps with the highest airflow. The 2-speed VerMar CAM Pro 2.9 delivers 3600 FPM on high speed
and an amazing 3000 FPM on its low setting.
The Cam Pro 2.9 is stackable and features two daisy-chain GFCI outlets; a 25’ power cord and built in cord wrap. Plus, you get safety light on the end of our power cord and a built in light on our two-speed switch. That’s two lights that guarantee you are receiving power to get the job done.
- 2 - Speed 1/3 Horsepower Motor
- GFCI Protected for Greater Safety
- Daisy-Chain up to Four Air movers
- Maximum velocities up to 3600 FPM
- Best Balanced Air Flow
- Stackable for Storage / Use
- Directional Airflow: Horizontal, 45º Angle ,90º Angle
Operating Instructions For Our Air Movers
1. Check the machine for any obstructions in the fan or airflow areas
before plugging in the unit or operation of the unit.
2. Set the machine in the desired orientation for operation.
3. Plug the power cord into a grounded outlet. Do not use an extension cord.
4. Check GFCI protection by pushing “TEST” button.
If operating properly, “RESET” button will pop out.
5. Do not plug more than 11 amps total into the GFCI outlet.
6. Ensure the switch is in the center OFF O position.
7. The machine has two power settings, Low | and High ||.
Always start in the HIGH position, then to LOW if desired.
8. When daisy-chaining, turn one unit on at a time to prevent excessive current inrush from starting multiple units at one time.
9. Every month, press the “TEST” button to verify that it cuts-off power to the GFCI. To restore power, press RESET. If the red LED begins to flash, the receptacle has lost GFCI protection and should be replaced immediately.
|
 |
